InvisibleSHIELD Full Body Protector - Sony Ericsson Satio

I was a little unsure after reading the problems people had with installation, but I found it is worth the effort. The key is to use alot of the liquid. (Mine came with a pot and a sponge rather than a spray). I found wiping a little on did nothing, but sqeesing a few large drops did the job. Rather than sticking to the surface it then glides easily about so you can position it well. I was also unsure about a few small air bubbles I'd managed to get at the top of the screen. A couple of days later, they had gone! I didnlt like th e idea of wetting the phone (even the outside), so I took the battery out first, Might be a good idea for anyone else trying it.

Desperately needed a cover to keep my brand new Satio free from scratches and inevitable drops. Managed to put the cover on successfully, without a hitch. Barring a few air bubbles which did begin to disappear. Took an hour to get everything onto the phone. Let it dry and everything looked fine. However a couple of days later after the cover had had some time to adjust and get stuck on properly i got a few problems. Found the bit attached to the touchscreen affected the touchscreen sensitivity. Too much for me. Got very annoyed. Secondly, some of the corners and edges of the shield began collecting dust and lint from pockets the phone had been in. In the end just pulled the cover off.

Ok, so this might not be the easiest cover to fit, but once you get the hang of it it's not too bad. I've had them on other phones so I knew what to expect. leave yourself plenty of time to fit it and don't rush it. one reviewer said they got fluff off the cloth stuck under the film - not sure how as you only need to use the cloth to dry bits of your phone AFTER youve fitted it. make sure you use plenty of the spray on both the phone and the film and it'll slide into place no problem, just keep some kitchen towel close to hand to soak up any liquid that comes out with the squeegy. As a tip, put it on in the evening so you can leave it overnight to dry. Since fitting mine i've dropped my satio a few times and there's still not a scratch on it. it might look a bit grubby after a while too, if it does, just use a wet wipe to clean it up and get it looking like new.

Tried to install this shield was an absolute disaster Followed the instructions without success I would not recommend this at all.

will have to purchase another screen protector and it certainly won't be the same again, did everything it told me top do and i still ended up with black bits from the cloth on the sticky side to go over the screen, not only this but it says the protector will slide into place when spayed lightly with the spary included, this does not happen could not slide it at all and had to keep trying to re-apply the protector